Rainbow Tassel Boho Slippers Free Crochet Pattern

Introduction

These Rainbow Tassel Boho Slippers are the perfect quick-win project for anyone who has just learned single crochet and wants to make something they can actually wear. Each slipper is simply a flat, striped rectangle that gets folded and seamed into shape, so there is no shaping, no increasing, and no confusing stitch counts to keep track of. The six bright rainbow bands run from toe to heel, and a little multicolored tassel on each side adds a playful boho touch. They feel soft and squishy underfoot, work up in an evening or two, and make a cheerful handmade gift for kids and grown-ups alike.

Materials Needed

• Yarn: Worsted weight (category 4) acrylic yarn in 6 colors, about 30 yd each per pair: A (red), B (orange), C (yellow), D (green), E (blue), F (purple).
• Hook: 5.0 mm (H/8) crochet hook.
• Notions: Tapestry needle, scissors, and a ruler or tape measure.
• Finished size: Child size fits ages 4–6, foot length approx. 6.5 in (16.5 cm). Adult size instructions are given in parentheses.

Abbreviations

• ch — chain: make a loop of yarn and pull it through the loop on your hook.
• sc — single crochet: insert hook into stitch, yarn over, pull up a loop, yarn over, pull through both loops.
• st(s) — stitch(es).
• yd — yard(s).

Gauge

14 sts and 16 rows = 4 inches (10 cm) in single crochet. To check, crochet a small swatch in single crochet and measure a 4-inch section; if you have more stitches than 14, go up a hook size, and if you have fewer, go down a hook size.

Tips Before You Start

• Keep your turning chains loose and your single crochets even; consistent tension is what makes the folded rectangle sit flat.
• Change colors on the last stitch of the row before the new color begins so the stripe edge stays neat.
• Make both slippers at the same time, row for row, so the stripes and fit match exactly.
• Try the slipper on before you finish the back seam; you can adjust the seam length for a snugger or looser fit.

Step-by-Step Instructions

Slipper (make 2)

With A, ch 31 (41).

Row 1: Sc in 2nd ch from hook and each ch across (30 (40) sc).

Rows 2–4: Ch 1, turn, sc in each st across (30 (40)).

Change to B.

Rows 5–8: Ch 1, turn, sc in each st across (30 (40)).

Change to C.

Rows 9–12: Ch 1, turn, sc in each st across (30 (40)).

Change to D.

Rows 13–16: Ch 1, turn, sc in each st across (30 (40)).

Change to E.

Rows 17–20: Ch 1, turn, sc in each st across (30 (40)).

Change to F.

Rows 21–24: Ch 1, turn, sc in each st across (30 (40)).

Fasten off.

Assembly

Fold the rectangle in half lengthwise with right sides together. Whipstitch or single crochet the two short ends together to form the heel. Then sew the long edges together from the heel for about 2.5 (3) inches to close the back seam, leaving the remaining long edges open for the foot opening. Turn right side out.

Tassel (make 4, 2 per slipper)

Cut 6 strands of each color (A–F) about 4 inches long. Hold the strands together, fold them in half, and attach to the side of the slipper at the seam (one tassel on each side) using a lark's head knot. Trim the ends evenly.

Edging (optional)

With A, sc evenly around the foot opening. Fasten off. Weave in ends.

Assembly and Finishing

Repeat the assembly steps for the second slipper so both are shaped the same. Weave in all yarn ends on the wrong side with your tapestry needle, taking care not to pull the fabric tight. Lightly mist or steam block each slipper to smooth the stripes and help the seams lie flat, then let them dry completely before wearing. Fluff and trim the tassels one last time so they hang evenly.

Pro Tips and Variations

• Swap the rainbow for two or three of your favorite colors for a simpler, more modern look.
• Add a non-slip sole by dabbing small dots of fabric paint or attaching a piece of suede to the bottom.
• Make matching slippers in any size by adding or removing chains in multiples of 2 to adjust the width.